P0E07: Generator Phase V Current Sensor Circuit High

What it means

The generator phase V current sensor circuit signal is above the expected range.

At a glance

• Usually lights the check-engine light
• The engine or gearbox may go into limp mode

How it works

The generator’s phase V current sensor measures current in the V phase of the hybrid motor-generator. The hybrid control module sets P0E07 when the phase V signal rises above its expected range, which can result from a signal wire short to battery voltage, an open sensor, or poor connector contact.

Common causes

Most likely first.

1. Signal wire shorted to B+
2. Open sensor
3. Connector pins corroded - high contact resistance

Symptoms

• Hybrid/EV system warning light on
• Reduced power or altered hybrid operation

How to diagnose it

1. Save freeze-frame data and compare phase V current data with phase U and other generator readings to see whether the high reading is isolated to phase V.
2. Inspect the phase V sensor connector and harness for corrosion, loose pins, or damaged insulation that could let the signal contact battery voltage.
3. Check the phase V sensor connector and verify its power, ground, and signal paths using the vehicle wiring diagram.
4. Test the phase V signal wire for a short to B+ and check continuity as specified by the manufacturer.
5. If the harness checks pass, test the phase V current sensor for an open or out-of-range output using the manufacturer’s procedure.

Common fixes

• Clean and secure corroded or loose phase V sensor connector pins.
• Repair the phase V signal wire if it is shorted to B+ or damaged.
• Replace the phase V current sensor if it is open or fails the specified output test.
• Clear the fault and confirm phase V readings are plausible alongside the other generator phases.

Can I keep driving?

The hybrid system may limit power or change generator operation when the phase V reading is implausibly high. Avoid hard acceleration and stop safely if the vehicle displays a stop or hybrid system warning.