OBD-II fault code

P2EA3: Exhaust Gas Temperature Sensor Circuit Low Bank 1 Sensor 6

What it means

The exhaust gas temperature sensor on bank 1 sensor 6 reports a circuit low fault. EGT measurement at this position is unreliable.

At a glance

  • Usually lights the check-engine light
  • Affects emissions; the car can fail an emissions test

How it works

Bank 1 sensor 6 measures exhaust temperature at its designated point on the cylinder 1 bank. The control module monitors its circuit and sets this code when the signal is lower than expected. A short to ground, a faulty sensor, or a wiring or connector problem can pull the reading low.

Common causes

Most likely first.

  1. Signal circuit shorted to ground
  2. Exhaust gas temperature sensor fault
  3. Wiring or connector fault

Symptoms

  • Check-engine light may be on
  • Reduced engine performance
  • Increased emissions or failed emissions test

How to diagnose it

  1. Record freeze-frame data and examine the bank 1 sensor 6 live reading for a value that is implausibly low or fixed.
  2. Locate bank 1 sensor 6 using service information and inspect its connector and harness for heat damage, corrosion, or a wire contacting ground.
  3. Check the sensor connector seating and terminal condition, then inspect the harness for breaks or chafing.
  4. Test the signal circuit for a short to ground and check sensor response against the manufacturer's specification.
  5. Repair the circuit fault or replace bank 1 sensor 6 if it fails testing with intact wiring.

Common fixes

  • Clean and secure the bank 1 sensor 6 connector.
  • Repair chafed or broken wiring, including a signal wire shorted to ground.
  • Replace bank 1 sensor 6 if the sensor itself fails testing.

Can I keep driving?

Reduced engine performance or increased emissions may result if the control module cannot use the bank 1 sensor 6 reading. Avoid hard acceleration and prolonged trips until the circuit is repaired.

A code shows where the control module detected a fault, not always which part failed. Check the causes in order and confirm with a test before replacing parts. Have several codes? Check them together

This is a generic code: it means the same on every make. The car’s maker may add more detail in its own service information.

Codes for the same component

Nearby codes