OBD-II fault code

P0DE8: Hybrid/EV Battery Pack Coolant Control Valve C Control Circuit/Open

What it means

The HV battery pack coolant control valve C reports a control circuit/open condition.

At a glance

  • Usually lights the check-engine light
  • The engine or gearbox may go into limp mode

How it works

Coolant control valve C directs battery-pack coolant through the path selected by the thermal management system. This code sets when the valve C control circuit is open, so the module may be unable to command the valve and regulate pack cooling as intended.

Common causes

Most likely first.

  1. Open in valve control wire
  2. Open actuator
  3. Pin pushed back out of connector body

Symptoms

  • EV/hybrid system warning light on
  • Reduced power output or limp mode
  • Charging may fail or be slowed
  • Reduced electric range

How to diagnose it

  1. Save freeze-frame data and hybrid or EV system codes, then note battery temperature and the commanded state of valve C.
  2. With the vehicle powered down according to its service instructions, inspect valve C's connector for loose or backed-out pins, corrosion, or damage.
  3. Inspect the valve C control harness for breaks, chafing, or other damage that could cause an open circuit.
  4. Test valve C circuit continuity and actuator resistance or operation only as specified by the manufacturer.
  5. If the wiring and actuator pass, test the module output controlling valve C.

Common fixes

  • Reconnect valve C or repair a backed-out or damaged connector pin.
  • Repair an open or damaged section of valve C control wiring.
  • Replace the valve C actuator if it fails the specified electrical test.
  • Repair the control module output if testing confirms it has failed.

Can I keep driving?

Avoid long trips, fast charging, and heavy power demands if a battery thermal warning or reduced-power message appears, because pack cooling may be compromised. Stop if the vehicle reports overheating or enters limp mode and arrange prompt diagnosis.

A code shows where the control module detected a fault, not always which part failed. Check the causes in order and confirm with a test before replacing parts. Have several codes? Check them together

This is a generic code: it means the same on every make. The car’s maker may add more detail in its own service information.

Codes for the same component

Nearby codes