What it means
The current sensor of the drive motor A reports a circuit range/performance fault. Current measurement is unreliable.
At a glance
- Usually lights the check-engine light
- The engine or gearbox may go into limp mode
How it works
Drive Motor A's current sensor measures current for inverter torque control, and the hybrid control system checks whether its readings remain plausible across operating conditions. This code sets when the sensor's output is outside its expected range or does not track current as expected, even if the circuit is not simply open or shorted. An offset shift or interference near the sensor can make the current measurement inaccurate.
Common causes
Most likely first.
- Current sensor offset drifted
- Magnetic offset from nearby parts
- Sensor element aged beyond calibration window
Symptoms
- EV/hybrid system warning light on
- Reduced motor power or torque
- Possible limp mode or vehicle shutdown
How to diagnose it
- Record freeze-frame data and compare Drive Motor A's reported current with commanded torque and motor operation for an implausible offset or inconsistent change.
- Check for related inverter or hybrid-system codes that may help distinguish a sensor calibration issue from a wider control fault.
- With the high-voltage system made safe according to service information, inspect Drive Motor A's current sensor, connector, and nearby components for damage, corrosion, or magnetic interference.
- Inspect the sensor wiring and its power and ground connections for damage or poor contact, then check them against the wiring diagram and manufacturer's specification.
- If the circuit and installation appear sound, test the sensor's output across operating conditions using the manufacturer's diagnostic procedure.
Common fixes
- Correct the sensor mounting or nearby magnetic interference if inspection identifies a problem.
- Repair damaged wiring or poor connections in Drive Motor A's current-sensor circuit.
- Clean and secure the sensor connector and terminals.
- Replace Drive Motor A's current sensor if its offset or output remains outside the manufacturer's specification.
- Repair an inverter fault if testing shows it is causing the implausible current reading.
Can I keep driving?
The hybrid system may limit torque or enter reduced-power mode, so avoid demanding acceleration and long trips until the fault is diagnosed. Stop safely if power becomes unreliable or a shutdown warning appears.
A code shows where the control module detected a fault, not always which part failed. Check the causes in order and confirm with a test before replacing parts. Have several codes? Check them together
This is a generic code: it means the same on every make. The car’s maker may add more detail in its own service information.