What it means
Voltage on the wastegate position sensor B signal line is below the expected window. Wire shorted to ground or sensor short.
At a glance
- Usually lights the check-engine light
- Affects emissions; the car can fail an emissions test
- The engine or gearbox may go into limp mode
How it works
Wastegate position sensor B reports turbocharger wastegate actuator position to the engine control module. P2ABB is set when sensor B's signal is lower than the expected range, which can result from a signal short to ground, a sensor fault, or an open or high-resistance signal or ground path.
Common causes
Most likely first.
- Signal wire shorted to ground
- Sensor fault
- Open or high-resistance signal/ground circuit
Symptoms
- Check-engine light may be on
- Reduced engine power
- Poor acceleration or turbo response
How to diagnose it
- Use freeze-frame and live data to confirm that wastegate sensor B reads low and compare it with the commanded actuator position.
- Inspect sensor B's connector and harness for corrosion, damaged insulation, pinched wires, or contact with ground.
- Check sensor B's signal wire for a short to ground and inspect its ground and reference connections using the wiring diagram.
- Measure the signal and check circuit continuity and resistance against the manufacturer's specification, looking for an open or high-resistance connection.
- If the wiring and connections pass, test wastegate sensor B and its actuator feedback before replacing the sensor.
Common fixes
- Clean and secure a corroded or loose sensor B connector.
- Repair a signal wire shorted to ground or a damaged ground connection.
- Repair an open or high-resistance section of the sensor B signal or ground circuit.
- Replace wastegate position sensor B if it produces a low signal despite a sound circuit.
Can I keep driving?
The module may limit boost or put the engine into limp mode, so avoid hard acceleration, towing, and high-speed driving. Stop somewhere safe if the power loss makes it difficult to keep up with traffic.
A code shows where the control module detected a fault, not always which part failed. Check the causes in order and confirm with a test before replacing parts. Have several codes? Check them together
This is a generic code: it means the same on every make. The car’s maker may add more detail in its own service information.