OBD-II fault code

P2615: Camshaft Position Signal Output Circuit Low

What it means

The camshaft position signal output circuit voltage is below the expected level. This code does not specify a camshaft A sensor or bank.

At a glance

  • Usually lights the check-engine light

How it works

The camshaft position signal output circuit sends a timing signal from the engine controller to a connected system or module. P2615 sets when the output voltage is below the expected level, often from a short to ground or a faulty output driver; this code does not name a particular camshaft, bank, or sensor.

Common causes

Most likely first.

  1. Output wire shorted to ground
  2. Output buffer transistor failed
  3. Connector pins corroded - high contact resistance

Symptoms

  • Check-engine light
  • Engine may crank longer, run poorly, or fail to start

How to diagnose it

  1. Record freeze-frame data and related timing codes, and note any extended cranking or rough running.
  2. Inspect the camshaft signal output wiring and connectors for chafing against ground, corrosion, loose terminals, or a pushed-back pin.
  3. With the circuit isolated as specified in service information, check the output wire for a short to ground.
  4. Check connector pin contact and continuity through the output circuit to locate excessive resistance or a damaged section.
  5. If the wiring checks out, verify the controller's signal output under the manufacturer's procedure.

Common fixes

  • Repair chafed output-wire insulation that is grounding the circuit.
  • Clean and secure corroded or loose connector terminals.
  • Repair damaged output-circuit wiring.
  • Repair or replace the controller only if its output driver is confirmed faulty.

Can I keep driving?

If the engine runs normally, limited driving may be possible, but poor running or a no-start can develop. Avoid long or high-risk trips until the signal circuit is checked.

A code shows where the control module detected a fault, not always which part failed. Check the causes in order and confirm with a test before replacing parts. Have several codes? Check them together

This is a generic code: it means the same on every make. The car’s maker may add more detail in its own service information.

Codes for the same component

Nearby codes