B0117: Camera Washer Actuator O

What it means

This code identifies a fault associated with Camera Washer Actuator O. The code alone does not specify the failure mode.

At a glance

• Usually lights the airbag (SRS) or body-system warning light

How it works

Camera Washer Actuator O controls one camera washer mechanism designated O by the vehicle system. The control module checks the actuator circuit when it is operated; this code points to a fault involving O but does not distinguish an electrical failure from a blocked or seized mechanism.

Common causes

Most likely first.

1. Failed camera washer actuator
2. Open or shorted actuator wiring
3. Loose, corroded, or damaged connector
4. Blown fuse or faulty driver circuit
5. Blocked or seized washer mechanism

Symptoms

• Warning light or symbol related to the affected system
• Comfort or safety function impaired

How to diagnose it

1. Save freeze-frame data and related body-system codes with a scan tool, then command actuator O if supported and check whether the fault is current or intermittent.
2. Identify the O washer assembly from vehicle service information and inspect its actuator, connector, harness, fluid hose, and nozzle for damage, corrosion, or obstruction.
3. Check the applicable fuse and verify power and ground at actuator O during operation.
4. Test the O circuit for open or shorted wiring and intermittent contact, including a careful harness movement check.
5. If the circuit checks out, inspect the mechanism for binding and compare actuator operation with the manufacturer's specification.

Common fixes

• Clear a blockage from the O washer path or free a stuck mechanism.
• Clean and reconnect the actuator O connector or repair damaged wiring.
• Replace a blown fuse after correcting the fault that caused it to fail.
• Replace a failed camera washer actuator O.
• Repair the actuator driver circuit if the O actuator and its circuit test correctly.

Can I keep driving?

You can usually drive if the camera image is clear, but the washer mechanism assigned to O may not clean it. Keep the lens clear yourself and use caution if the affected camera supports a safety or visibility function.