B0114: Camera Washer Actuator L

What it means

This code identifies a fault associated with Camera Washer Actuator L. The code alone does not specify the failure mode.

At a glance

• Usually lights the airbag (SRS) or body-system warning light

How it works

Camera Washer Actuator L operates one of the vehicle's camera washer mechanisms. The control module monitors its electrical operation when commanded; this code flags a fault associated with actuator L without specifying whether it is electrical or mechanical.

Common causes

Most likely first.

1. Failed camera washer actuator
2. Open or shorted actuator wiring
3. Loose, corroded, or damaged connector
4. Blown fuse or faulty driver circuit
5. Blocked or seized washer mechanism

Symptoms

• Warning light or symbol related to the affected system
• Comfort or safety function impaired

How to diagnose it

1. Use a scan tool to save freeze-frame data and related body-system codes, then command actuator L if the tool supports it and note whether the fault returns.
2. Confirm which camera washer mechanism is labelled L in the vehicle wiring information, then inspect that actuator, its connector, harness, fluid path, and nozzle for damage or blockage.
3. Check the associated fuse and measure power and ground at actuator L during a washer command.
4. With the circuit isolated as directed by vehicle service information, check actuator L wiring for opens, shorts, and intermittent faults while gently moving the harness.
5. If wiring and supply are correct, check for a seized mechanism and test the L actuator against the manufacturer's specification.

Common fixes

• Remove debris blocking the L washer nozzle or mechanism.
• Clean and secure the actuator L connector or repair its damaged wiring.
• Replace a fuse that has failed after finding and correcting the cause.
• Replace a camera washer actuator L that fails its test.
• Repair the actuator driver circuit if actuator L and its wiring pass inspection.

Can I keep driving?

Driving is generally possible if the camera lens stays clear, but the washer mechanism controlled by actuator L may be unavailable. Clean the lens before relying on that camera, especially in rain, road spray, or dusty conditions.