Cadillac XLR recalls

4 official safety recalls for the Cadillac XLR from NHTSA (United States), DVSA (United Kingdom) and the EU Safety Gate, newest first. Recall repairs are normally free at the maker’s dealers.

Whether your car is affected and still needs the repair depends on its VIN or registration. Check it on the official site for your country:

  1. Turn signal bulb may burn out early

    Reported July 19, 2006Model years 2004–2005NHTSA campaign 06V2630007,689 vehicles affected

    Vibration in a loose socket or air entering through a poor seal may damage the shared daylight running light, turn signal and parking lamp bulb, causing it to burn out early. The lost lights may fail to warn others of the vehicle's presence or intentions. Dealers will replace both sockets and bulbs free of charge.

    Official NHTSA recall text
    Component
    EXTERIOR LIGHTING:TURN SIGNAL
    Defect
    ON CERTAIN PASSENGER VEHICLES, THE DAYLIGHT RUNNING LIGHTS (DRL), TURN SIGNAL, AND PARKING LAMPS USE THE SAME BULB. THE BULB MAY BECOME DAMAGED FROM VIBRATION WITHIN A LOOSE FITTING SOCKET OR AIR ENTERING THE BULB DUE TO AN INADEQUATE SEAL. BOTH OF THESE CONDITIONS WILL CAUSE THE BULB TO BURN OUT PREMATURELY.
    Consequence
    IF THIS WERE TO OCCUR, THE DRIVER WOULD NOTICE THAT THE ARROW IN THE INSTRUMENT PANEL WOULD FLASH FASTER THAN NORMAL WHEN THE TURN SIGNAL IS ACTIVATED. THE LOSS OF THE DRL AND TURN SIGNALS COULD FAIL TO WARN OTHERS OF THE DRIVER'S PRESENCE OR INTENTIONS AND COULD LEAD TO A VEHICLE CRASH.
    Remedy
    DEALERS WILL REPLACE THE SOCKET AND BULB IN BOTH LAMPS FREE OF CHARGE. THE RECALL BEGAN ON JULY 31, 2006. OWNERS MAY CONTACT CADILLAC AT 1-866-982-2339.
    Notes
    GENERAL MOTORS RECALL NO. 06013.CUSTOMERS MAY ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY 1-800-424-9153), OR GO TO HTTP://WWW.SAFERCAR.GOV.

  2. Accelerator pedal may not return to idle

    Reported February 9, 2005Model years 2004NHTSA campaign 05V04600019,924 vehicles affected

    If one of the accelerator pedal return springs fails in temperatures from -22 degrees F to -40 degrees F, the engine may not return to idle within three seconds. Stopping may require more brake pedal force and a longer distance. Dealers will replace the accelerator pedal assembly.

    Official NHTSA recall text
    Component
    VEHICLE SPEED CONTROL:ACCELERATOR PEDAL
    Defect
    CERTAIN PASSENGER VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 124, 'ACCELERATOR CONTROL SYSTEMS.' IF ONE OF THE TWO ACCELERATOR PEDAL RETURN SPRINGS FAILS AND THE TEMPERATURE IS -22 DEGREES F TO -40 DEGREES F, THE ENGINE MAY NOT RETURN TO IDLE WITHIN THREE SECONDS, AS REQUIRED.
    Consequence
    IF THIS WERE TO OCCUR, GREATER BRAKE PEDAL FORCE AND A LONGER DISTANCE MAY BE REQUIRED TO STOP THE VEHICLE.
    Remedy
    DEALERS WILL REPLACE THE ACCELERATOR PEDAL ASSEMBLY. THIS RECALL BEGAN ON MARCH 8, 2005. OWNERS MAY CONTACT CADILLAC AT 1-866-982-2339 OR PONTIAC AT 1-800-620-7668.
    Notes
    GM RECALL NO. 05018.CUSTOMERS MAY ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY 1-800-424-9153), OR GO TO HTTP://WWW.SAFERCAR.GOV.

  3. Rear brake lines may overheat

    Reported November 3, 2004Model years 2004–2005NHTSA campaign 04V5250005,225 vehicles affected

    Heat from the exhaust may cause brake fluid in a rear line to boil, reducing braking effectiveness and potentially causing a leak and loss of brake fluid. Dealers will check clearances, reposition components and inspect the lines, repairing or replacing them if worn.

    Official NHTSA recall text
    Component
    SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS
    Defect
    CERTAIN PASSENGER VEHICLES WERE PRODUCED WITH ONE OR BOTH REAR BRAKE HYDRAULIC LINES THAT CAN COME IN CONTACT WITH OR BE AFFECTED BY HEAT FROM THE LEFT ENGINE EXHAUST MANIFOLD AND THE LEFT EXHAUST PIPE. THE BRAKE FLUID COULD REACH ELEVATED TEMPERATURES AND BOIL.
    Consequence
    IF THE BRAKE FLUID BOILS IN A REAR BRAKE LINE, THE EFFECTIVENESS OF THE REAR BRAKE SYSTEM WOULD BE REDUCED WHICH COULD RESULT IN A BRAKE LINE LEAK AND LOSS OF BRAKE FLUID. IF ENOUGH FLUID LEAKS FROM THE REAR BRAKE SYSTEM SO THAT BRAKE PEDAL APPLICATION CAN NO LONGER BUILD PRESSURE TO THE REAR BRAKES. THE OPERATOR OF THE VEHICLE WILL EXPERIENCE LIMITED BRAKING WHICH COULD RESULT IN A CRASH.
    Remedy
    DEALERS WILL (1) INSPECT THE LEFT ENGINE EXHAUST MANIFOLD CLIP FOR PROPER ALIGNMENT AND PLACEMENT ON THE BODY-MOUNTED STUD. IF INCORRECT, THEY WILL REPOSITION THE CLIP ON THE BRAKE LINES AND REINSTALL THE CLIP ON THE STUD; (2) THE DEALER WILL VERIFY THAT BOTH REAR BRAKE LINES HAVE THE PROPER CLEARANCE TO THE LEFT EXHAUST PIPE. THEY WILL REPOSITION THE LINES BY BENDING AS NECESSARY; (3) DEALERS WILL REMOVE THE MACHINING TAB FROM THE REAR DIFFERENTIAL HOUSING. ALSO, DEALERS ARE TO INSPECT THE BRAKE LINES FOR WEAR IN THESE RELATED AREAS AND REPAIR OR REPLACE IF THERE IS ANY SIGN OF WEAR-THROUGH ON THE NYLON OVERCOATING. THE RECALL BEGAN ON JANUARY 18, 2005. OWNERS SHOULD CONTACT CADILLAC AT 1-866-982-2239 OR CHEVROLET AT 1-800-630-2438.
    Notes
    GENERAL MOTORS RECALL NO. 04086.CUSTOMERS CAN ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-888-DASH-2-DOT (1-888-327-4236).

  4. Control arm joint may separate

    Reported June 9, 2004Model years 2004NHTSA campaign 04V27300041,928 vehicles affected

    Washers made from the wrong material may fracture, reducing the clamp load and allowing the control arm to separate from the steering knuckle. The wheel could tilt or separate, and its brake hose could be severed, reducing braking and potentially causing a crash. Dealers will inspect the joints and replace parts as needed.

    Official NHTSA recall text
    Component
    STEERING:LINKAGES
    Defect
    ON CERTAIN PASSENGER VEHICLES INVOLVED IN THIS CAMPAIGN, THE LOWER CONTROL ARM BALL STUD NUT/WASHER ASSEMBLIES WITH WASHERS WERE MADE OF THE WRONG MATERIAL. THE WASHERS MAY FRACTURE AND BECOME LOOSE OR FALL AWAY FROM THE VEHICLE, REDUCING CLAMP LOAD. SEPARATION OF THE CONTROL ARM BALL STUD AND STEERING KNUCKLE, DUE TO DISENGAGEMENT OF THE TAPERED ATTACHMENT AND RETAINING NUT, IS POSSIBLE.
    Consequence
    IF THE CONTROL ARM SEPARATES FROM THE KNUCKLE, THE AFFECTED CORNER OF THE VEHICLE WILL DROP AND THE CONTROL ARM WOULD BE FORCED DOWNWARD, CONTACTING THE WHEEL. THE AFFECTED WHEEL COULD TILT OUTWARD AND CREATE A DRAGGING ACTION THAT WOULD TEND TO SLOW THE VEHICLE AND CREATE A TENDENCY FOR THE VEHICLE TO TURN IN THE DIRECTION OF THE AFFECTED WHEEL. IN EXTREME SITUATIONS, THE AFFECTED WHEEL ASSEMBLY COULD SEPARATE FROM THE VEHICLE. SEPARATION OF THE WHEEL ASSEMBLY WOULD ALSO SEVER THAT WHEEL;S HYDRAULIC BRAKE HOSE AND RESULT IN DIMINISHED BRAKING PERFORMANCE OF THE VEHICLE, WHICH COULD RESULT IN A CRASH.
    Remedy
    DEALERS WILL INSPECT THE BALL STUD JOINTS AND MEASURE THE TORQUE OF THE NUT FOR ALL FRONT LOWER CONTROL ARMS IN ALL MODELS AFFECTED AS WELL AS THE REAR LOWER CONTROL ARMS ON THE XLR AND CORVETTE. IF THE TORQUE IS NOT AT SPECIFICATION, THE DEALERS WILL REPLACE THE BALL STUD, THE KNUCKLE, AND THE NUT. IF THE TORQUE IS AT SPECIFICATION, THE DEALERS WILL REPLACE THE NUT/WASHER ASSEMBLY ONLY. THE RECALL WILL BEGIN ON AUGUST 25, 2004. OWNERS SHOULD CONTACT CADILLAC AT 1-866-982-2339 OR CHEVROLET AT 1-800-630-2438.
    Notes
    GM RECALL NO. 04043. CUSTOMERS CAN ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-888-DASH-2-DOT (1-888-327-4236).

Sources: NHTSA (US National Highway Traffic Safety Administration), DVSA (UK Driver and Vehicle Standards Agency) and the EU Safety Gate (European Commission) recall data. Each recall covers vehicles sold in that market; models sold elsewhere may differ.

Back to the Cadillac XLR