What it means
The control module detects that the control pilot indicator control circuit is operating outside its expected range or performance. The effect depends on the vehicle.
At a glance
- Usually lights the check-engine light
How it works
The control pilot indicator control circuit carries a signal associated with the vehicle’s charging pilot indication, which the control module monitors for expected behavior. P0E69 sets when that signal is outside its expected range or performance, potentially affecting the charge-status indication or charging operation.
Common causes
Most likely first.
- Connector not seated
- Wire chafing intermittent
- Connector with intermittent contact under vibration
Symptoms
- Charge status indicator shows fault
- Charging may not start or interrupts
- Slower-than-expected charge rate
How to diagnose it
- Use a scan tool to record freeze-frame data and check the control pilot indicator circuit status during a charging attempt.
- With the vehicle safely powered down, inspect the control pilot indicator connector and confirm it is fully seated.
- Examine the pilot-indicator wiring for chafing, pin damage, or intermittent contact at the connector.
- Following the service procedure, monitor the signal while gently moving the accessible harness to identify vibration-sensitive interruptions.
- Measure the circuit and its connections against the manufacturer’s specification to locate a range or performance fault.
Common fixes
- Reseat and secure the control pilot indicator connector.
- Repair chafed or damaged pilot-indicator wiring.
- Clean or repair connector pins with intermittent contact.
- Replace the affected indicator or control component only if circuit testing confirms it has failed.
Can I keep driving?
Check that charging actually starts and remains active, since the fault can affect the charge indication as well as charging behavior. Avoid relying on an unverified charge level, and follow the vehicle’s safety guidance if a high-voltage warning or reduced power appears.
A code shows where the control module detected a fault, not always which part failed. Check the causes in order and confirm with a test before replacing parts. Have several codes? Check them together
This is a generic code: it means the same on every make. The car’s maker may add more detail in its own service information.