OBD-II fault code

C054E: Vacuum Sensor B Range/Performance

What it means

Vacuum Sensor B Range/Performance: the signal is implausible or outside the valid range.

How it works

Vacuum sensor B reports vacuum information used by the control module to assess brake-assist availability. C054E sets when sensor B's signal is present but is implausible or outside the range the module expects.

Common causes

Most likely first.

  1. Vacuum sensor fault
  2. Wiring or connector fault
  3. Vacuum supply or hose problem

Symptoms

  • Brake or stability-control warning light on
  • Brake assist may be affected

How to diagnose it

  1. Record freeze-frame data and review live data for vacuum sensor B to see whether its reading is out of range or fails to respond as conditions change.
  2. Inspect sensor B's connector and wiring for loose pins, corrosion, chafing, or damage that could distort its signal.
  3. Check the vacuum hose and supply serving sensor B for disconnection, cracking, blockage, or leakage.
  4. Compare sensor B's reading with the vehicle's other available vacuum data and operating conditions to identify an implausible sensor response.
  5. Test sensor B and its circuit according to vehicle wiring information and the manufacturer's specification before replacing parts.

Common fixes

  • Reconnect or replace a damaged, leaking, or obstructed vacuum hose serving sensor B.
  • Repair damaged wiring or clean and secure sensor B's connector terminals.
  • Replace vacuum sensor B if its output remains implausible after its supply and circuit pass inspection.
  • Correct a vacuum supply fault if testing identifies one.

Can I keep driving?

Use caution and allow extra stopping distance because brake assist may be affected. Avoid driving if the brake pedal feels unusually hard or braking performance changes.

A code shows where the control module detected a fault, not always which part failed. Check the causes in order and confirm with a test before replacing parts. Have several codes? Check them together

This is a generic code: it means the same on every make. The car’s maker may add more detail in its own service information.

Codes for the same component

Nearby codes