Toyota Proace City recalls
8 official safety recalls for the Toyota Proace City from NHTSA (United States), DVSA (United Kingdom) and the EU Safety Gate, newest first. Recall repairs are normally free at the maker’s dealers.
Whether your car is affected and still needs the repair depends on its VIN or registration. Check it on the official site for your country:
- United States: nhtsa.gov/recalls
- United Kingdom: check-vehicle-recalls.service.gov.uk
Water pump pulley may slip or detach
The water pump pulley may slip, misaligning the timing belt and causing engine shutdown or loss of power. The pulley may also detach, leaving vehicle components on the road. The engine water pump will be replaced.
Official DVSA recall text
- Component
- Water pump replacement on certain Toyota Proace and Proace City
- Defect
- ââVehicles equipped with a 1.5L engine may be subject to engine failure and loss of engine power caused by water pump pulley slippage. This condition may result in timing belt misalignment and engine shutdown. The pulley may detach from the shaft leading to the loss of vehicle components on the roadway and complete loss of engine power increasing the risk of an accident.â
- Remedy
- ââEngine Water Pump Replacementâ
Fuel rail may leak
Fuel may leak from the common rail, creating vapour and allowing fuel to flow towards the hot exhaust, with a risk of a thermal event. The common rail will be checked and replaced if necessary.
Official DVSA recall text
- Component
- Potential defect of fuel supply rail on certain Toyota Proace and Proace City
- Defect
- For certain vehicles equipped with diesel engines there is a possibility that you may experience fuel leakage from the common rail. As a result fuel leaking between the nut and the common rail cone may create fuel vapour and fuel flow towards the hot exhaust system with a risk of a thermal event.
- Remedy
- Check and if required replacement of the common rail.
Software bug may black out both displays
A software bug may cause the multimedia screen and instrument cluster to turn completely black after the ignition is switched on. The problem is permanent once it occurs. Accept and install the over-the-air update.
Official DVSA recall text
- Component
- In-Vehicle Infotainment ECU software update via OTA on certain Toyota Proace and Proace City
- Defect
- For affected vehicles both displays (the multimedia screen and the instrument cluster) may turn completely black after ignition is turned ON due to a software bug. When this condition occurs the issue is permanent.
- Remedy
- Accept and successfully install an Over the Air (OTA) update.
Tyre pressure warning may be delayed or false
The tyre pressure monitoring system may fail to illuminate its warning light, illuminate it late, or give a false warning. The electronic stability control software calibration will be updated.
Official DVSA recall text
- Component
- Inconsistent Tyre pressure monitoring system alert on certain Toyota Proace City
- Defect
- For certain vehicles the indirect tyre pressure monitoring within the Electronic Stability Control (ESC) software may result in the warning light not illuminating illuminating with a delay or triggering a false warning.
- Remedy
- Update to the software calibration of the Electronic Stability Control unit (ESC).
Camshaft chain may wear prematurely and break
Premature camshaft chain wear under high engine speed and load may cause abnormal noise or chain breakage. The chain will be inspected and replaced if required, and the engine control unit software will be updated.
Official DVSA recall text
- Component
- Engine camshaft chain potential breakage on Certain Toyota Proace City and Proace
- Defect
- For affected vehicles equipped with the 1.5L diesel engine there is a possibility that premature wear of the camshaft chain may occur. Premature wear occurs primarily due to chain design which causes excessive tension in high engine speed and high engine load conditions which can lead to abnormal noise and risk of breakage of the chain.
- Remedy
- Inspection of the camshaft chain replace where required and update the engine ECU software
Battery control unit software may cause loss of drive
Incorrect traction battery control unit software may falsely detect cell voltage or temperature, which could lead to loss of drive. The software will be updated.
Official DVSA recall text
- Component
- Insufficient Traction battery control unit software on certain Toyota Proace City BEV and Proace BEV
- Defect
- For affected vehicles there is an error in the specific software calibrations of the traction (high voltage) battery control unit. As a consequence a false detection of the battery cell voltage and/or the battery temperature could occur leading to loss of drive.
- Remedy
- Update the software of the traction battery control unit.
Engine software may not switch on emissions warning light
A software calibration error may prevent the warning light from coming on when urea consumption falls below its target threshold. The engine control unit software will be updated.
Official DVSA recall text
- Component
- On certain vehicles there is an error in the specific software calibration of the Engine Electronic Control Unit. As a consequence the Malfunction Indicator Light (MIL) will not turn ON when the urea consumption (which is part of the exhaust after treatment system) is lower than target threshold.
- Defect
- On certain vehicles there is an error in the specific software calibration of the Engine Electronic Control Unit. As a consequence the Malfunction Indicator Light (MIL) will not turn ON when the urea consumption (which is part of the exhaust after treatment system) is lower than target threshold.
- Remedy
- Update the software of the Engine Electronic Control Unit
Rear tyres may have insufficient load capacity
The rear tyres' load capacity is below the maximum permitted load. This could cause loss of control and an accident. The product is recalled from end users.
Official EU Safety Gate text
- Component
- Injuries
- Defect
- The loading capacity of the rear tyres is lower than its maximum permitted load. This could lead to a loss of control over the vehicle, creating a risk of an accident. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
- Remedy
- Recall of the product from end users
- Notes
- Notified by France
Sources: NHTSA (US National Highway Traffic Safety Administration), DVSA (UK Driver and Vehicle Standards Agency) and the EU Safety Gate (European Commission) recall data. Each recall covers vehicles sold in that market; models sold elsewhere may differ.