Peugeot 807 recalls
21 official safety recalls for the Peugeot 807 from NHTSA (United States), DVSA (United Kingdom) and the EU Safety Gate, newest first. Recall repairs are normally free at the maker’s dealers.
Whether your car is affected and still needs the repair depends on its VIN or registration. Check it on the official site for your country:
- United States: nhtsa.gov/recalls
- United Kingdom: check-vehicle-recalls.service.gov.uk
Fuel heater may cause a fuel leak
A defective fuel heater may overheat its electrical connector, distort the cover and let air into the fuel circuit, making the engine difficult or impossible to start. A diesel leak may also develop. The cover will be replaced and the connector inspected and replaced if necessary.
Official DVSA recall text
- Component
- FUEL MAY LEAK
- Defect
- The fuel heating device integrated in to the diesel fuel filter cover may be defective and allow heat to build up within the electrical supply connector causing the cover to distort and air to enter the fuel circuit. This could make the vehicles difficult to start and a warning light will be illuminated on the dash board. The engine could be difficult or not possible to start. In the worst cases a diesel fuel leak could eventually appear.
- Remedy
- Recall the vehicles that are likely to be affected and replace the fuel heater cover. Additionally the electrical connector will be inspected and where necessary replaced.
Steering column link bolt may be too loose
The steering column link bolt may be incorrectly tightened, allowing movement between the steering wheel and shaft. A rattle may warn the driver; if ignored, steering control could be reduced. The bolt will be checked and retightened if needed.
Official DVSA recall text
- Component
- POTENTIAL FOR REDUCED STEERING CONTROL
- Defect
- The steering column link bolt which retains the steering wheel to the steering column may not have been tighten to the correct specification. This can result in a gradual increase in movement between the steering wheel and shaft with an associated rattle. This should identify the issue to the driver however if the driver does not heed this warning then the steering control of the vehicle could be reduced.
- Remedy
- Recall all affected vehicles to check and if required re-torque the steering column link bolt.
Front tyre may rip and deflate
The front left tyre may have localised tread or inner-side damage from transport. It may rip and deflate. The tyre will be visually checked and replaced if necessary.
Official DVSA recall text
- Component
- TYRE MAY DEFLATE
- Defect
- Some tyres may have suffered superficial damage when the vehicle was being transported. The front Left hand tyre may have localised damage on the tread or the inner side. The tyre may rip and deflate.
- Remedy
- Carry out a visual check of the condition of the tyre in the affected areas and replace the tyre if necessary.
Power steering wiring may be damaged
The power steering motor wiring may contact other engine bay components, which could affect power steering assistance. Protection will be fitted to the wiring harness.
Official DVSA recall text
- Component
- POWER STEERING ASSISTANCE MAY FAIL.
- Defect
- It is possible that the wiring harness for the power assisted steering motor may come in contact with other components in the engine bay. Should this occur then it is possible that the power steering assistance on this large vehicle may become affected.
- Remedy
- Recall affected vehicles and fit protection to the wiring harness.
Brake vacuum pump valve may reduce assistance
In rare circumstances, the brake vacuum pump one-way valve may not work correctly, reducing braking assistance. The valve will be replaced.
Official DVSA recall text
- Component
- BRAKING ASSISTANCE MAY NOT PERFORM CORRECTLY
- Defect
- In very rare circumstances the vacuum pump one way valve may not function correctly which could affect the level of braking assistance.
- Remedy
- Recall the vehicles that are likely to be affected to replace the brake vacuum pump one way valve.
Exterior lights may switch off without warning
The lighting system may fail to detect the control ring position, causing the exterior lights to switch off without warning. The lighting management software will be updated.
Official DVSA recall text
- Component
- LIGHTS MAY FAIL WITHOUT WARNING.
- Defect
- It has been identified that the position of the exterior lighting control ring may not be detected by the lighting management system and the lights may switch off without warning.
- Remedy
- Recalled vehicles will have the lighting management software updated.
Brake linkage rod may reduce braking efficiency
The threaded portion of the brake linkage rod may not meet requirements, reducing braking efficiency. The rod will be checked and replaced if it does not conform.
Official DVSA recall text
- Component
- BRAKING EFFICIENCY MAY BE COMPROMISED
- Defect
- The threaded portion of the brake linkage rod in the brake control system may not be to conformity. This could result in a reduction of braking efficiency.
- Remedy
- Recall affected vehicles to check rod and replace if found not to meet conformity.
Exterior lights may switch off without warning
The lighting system may misread the exterior light control switch position and switch the lights off without warning. The lighting management software will be updated.
Official DVSA recall text
- Component
- VEHICLE EXTERIOR LIGHTS MAY FAIL WITHOUT WARNING
- Defect
- The lighting management system may incorrectly detect the position of the exterior lighting control switch. This may cause the exterior light to switch off without warning.
- Remedy
- Recall all affected vehicles and install a new version of the exterior lighting management software to the vehicle.
Diesel fuel return pipe may wear through
Play in the fuel return pipe mountings may cause the pipe to abrade and wear over time. The clips will be checked and the pipe secured.
Official DVSA recall text
- Component
- DIESEL FUEL RETURN PIPE MAY ABRADE AND WEAR.
- Defect
- It has been identified that a slight amount of play in the diesel fuel return pipe mountings on certain vehicles may over time lead to abrasion and wear of the pipe.
- Remedy
- Recalled vehicles will have the subject clips checked and the pipe secured.
Brake vacuum pump may reduce braking efficiency
A fault in the brake vacuum pump may harden the brake pedal and reduce braking efficiency. Dealers will replace the pump.
Official DVSA recall text
- Component
- REDUCED BRAKING PERFORMANCE
- Defect
- It has been identified that on the specified vehicles a fault may develop with the brake vacuum pump. This can result in hardening of the brake pedal with an attendant loss of braking efficiency.
- Remedy
- Recalled vehicles will have the vacuum pump replaced.
Heatshield may damage rear brake hose
The exhaust heatshield may contact a rear brake hose and, in extreme cases, cause a brake fluid leak and extended brake pedal travel. The shield will be checked and adjusted if needed; a hose showing rubbing contact will be replaced.
Official DVSA recall text
- Component
- POSSIBILITY OF BRAKE FLUID LEAKAGE.
- Defect
- It has been identified that the heat shield which protects the exhaust system may contact one of the rear brake hoses. In extreme situations this may cause leakage within a brake circuit which would be represented by extended brake pedal travel.
- Remedy
- Recalled vehicles will be checked for heat shield to brake hose contact and if necessary the shield will be adjusted. The brake hose will be replaced if rubbing contact has been made.
Seat belt may lock too slowly
The seat belt locking action may be slower than designed. The remedy is to check the seat belts' manufacture dates and replace them where necessary.
Official DVSA recall text
- Component
- SEAT BELT BRACING ACTION MAY BE AFFECTED
- Defect
- The seat belt locking action may not be as fast as it is designed to be.
- Remedy
- Recall the vehicles that may be affected to check the date of manufacture of the seat belts and where necessary replace the seat belts.
Moisture in vacuum circuit may affect braking assistance
Moisture may collect and freeze in the vacuum circuit, adversely affecting braking assistance. A filtered air vent will be fitted to each electro valve in the circuit.
Official DVSA recall text
- Component
- BRAKING EFFICIENCY MAY BE AFFECTED
- Defect
- Braking assistance could be adversely by freezing of moisture that may accumulate in the vacuum circuit.
- Remedy
- Recall the vehicles that may be affected and fit a separate air vent complete with filter to each electro valve fitted to the vacuum circuit.
Engine fuel leak may prevent restart
A fault in the engine management system may allow fuel to leak through the injectors after switch-off. Excess fuel may prevent the engine from restarting. The engine management software will be updated.
Official DVSA recall text
- Component
- FUEL MAY LEAK
- Defect
- Due to a potential fault in the engine management system an internal engine fuel leak via the injectors may occur following switching off. This would result in the engine failing to restart due to excess fuel being present in the inlet manifold or cylinders.
- Remedy
- To address the issue recalled vehicles will receive an engine management download.
Brake pipe may chafe and leak
A brake pipe may rub against a turbocharger intake clip and wear through, causing a brake circuit leak and the red brake warning light to come on. The pipe will be checked, the clip moved if needed, and a worn pipe replaced.
Official DVSA recall text
- Component
- BRAKE CIRCUIT MAY LEAK
- Defect
- Under certain circumstances a brake pipe may chafe on the turbo charger air intake securing clip. In extreme situations the wear caused could lead to leakage within a brake circuit and the illumination of the red brake warning light.
- Remedy
- Recalled vehicles will be checked for the chafe condition and if necessary the turbo air intake securing clip will be relocated. The affected brake pipe will also be changed if it displays any sign of wear.
Water ingress may affect airbag operation
Poor air-conditioning drainage can let water run under the carpet, causing the airbag warning light to come on or, in extreme cases, the airbag system to malfunction. The drainage tube and anti-return valve will be modified.
Official DVSA recall text
- Component
- AIRBAG SYSTEM MAY MALFUNCTION
- Defect
- Some cases have been found where inadequate drainage of water condensing from the air conditioning system has caused water to run under the carpet. This in turn may lead to the airbag warning light coming on or in extreme cases lead to airbag systems malfunctioning.
- Remedy
- Recall the vehicles that are likely to be affected for modification of the drainage tube and the anti return valve.
Throttle stop may break and reduce braking assistance
Erratic motorised throttle operation could break the throttle stop, putting the engine into limp-home mode and possibly reducing braking assistance. Dealers will install updated engine ECU software.
Official DVSA recall text
- Component
- FAILURE OF THE THROTTLE STOP COULD LEAD TO A REDUCTION IN BRAKING ASSISTANCE
- Defect
- The original engine software may cause erratic operation of the motorised throttle body. This could in rare extreme cases cause the throttle stop to break. This will cause the engine to revert to limp home mode which possible may cause a reduction in braking assistance.
- Remedy
- Install updated software in the engine ECU.
Heater blower may short circuit
Defective heater blower components could cause a short circuit and loss of passenger compartment ventilation, and in extreme conditions could start a fire in the wiring harness. Replace the heater blower module.
Official DVSA recall text
- Component
- RISK OF FIRE - HEATER BLOWER MODULE
- Defect
- There is a possibility of defective components in the heater blower which could cause a short circuit and loss of ventilation of the passenger compartment and in an extreme condition could set fire to the wiring harness.
- Remedy
- Recall affected vehicles and replace heater blower module
Water ingress may cause premature airbag deployment
Water may enter the airbag control unit compartment and cause premature airbag deployment. The compartment will be sealed.
Official DVSA recall text
- Component
- WATER INGRESS INTO THE AIRBAG ECU
- Defect
- There is a possibility that water may ingress into the airbag electronic control unit (ECU) compartment. This may cause premature deployment of the airbag.
- Remedy
- Seal the airbag ECU compartment.
Sliding door safety lock may be disabled
An electrical signal could disable the sliding door safety lock, allowing a door to open while the vehicle is moving. The door electronic control unit will be replaced.
Official DVSA recall text
- Component
- ELECTRICAL SIGNAL COULD NEUTRALISE THE SLIDING DOOR SAFETY LOCK
- Defect
- There is a possibility that the electric sliding doors may open whilst the vehicle is in motion.
- Remedy
- Fit a replacement electronic control unit to the door.
Third-row rear bench seat may not lock
The third-row rear bench seat may not lock in place and could tip forward during harsh deceleration. The check strap routing will be modified.
Official DVSA recall text
- Component
- REAR BENCH SEAT MAY NOT LOCK IN PLACE
- Defect
- Rear bench seat in third row may not lock in place and tip forward during harsh deceleration
- Remedy
- Recall affected vehicles and modify routing of check strap.
Sources: NHTSA (US National Highway Traffic Safety Administration), DVSA (UK Driver and Vehicle Standards Agency) and the EU Safety Gate (European Commission) recall data. Each recall covers vehicles sold in that market; models sold elsewhere may differ.