P23FC: Cylinder 11 Injector B Air-Fuel Ratio Imbalance

What it means

The control module detects an air-fuel ratio imbalance associated with injector B for cylinder 11. The code identifies an imbalance, but does not by itself establish that the injector has a particular fault.

At a glance

• Usually lights the check-engine light
• Affects emissions; the car can fail an emissions test

How it works

Injector B is the second injector identified for cylinder 11 in systems that use this naming. The control module evaluates cylinder-specific combustion and mixture feedback for signs that cylinder 11 is receiving or burning a different fuel-air mixture than expected; this code sets when the imbalance is linked to that injector and exceeds the module's threshold.

Common causes

Most likely first.

1. Injector B flow or delivery fault
2. Injector B circuit or wiring fault
3. Other cylinder-specific air or fuel imbalance

Symptoms

• Check-engine light on
• Rough idle or engine vibration
• Reduced power
• Increased fuel consumption

How to diagnose it

1. Record freeze-frame data and review live misfire or cylinder-balance and fuel-trim information to see when cylinder 11's imbalance occurs.
2. Inspect injector B at cylinder 11 and its connector and harness for looseness, corrosion, chafing, or damage that could affect fuel delivery or its control signal.
3. Check for other codes and inspect cylinder 11 for air leaks or other cylinder-specific mixture problems before assuming the injector itself is faulty.
4. Test injector B's electrical circuit and compare its control and supply behavior with the manufacturer's specification and a comparable injector circuit.
5. If the circuit checks out, have injector B's operation and flow assessed using the vehicle's specified test procedure, then compare cylinder 11's response with other cylinders.

Common fixes

• Reconnect or repair a loose, corroded, or damaged injector B connector or wiring at cylinder 11.
• Repair a confirmed air leak or other cylinder 11 mixture problem.
• Clean or service injector B if testing confirms restricted delivery and the manufacturer's procedure permits it.
• Replace injector B for cylinder 11 if testing confirms a faulty injector.
• Repair a confirmed injector driver or control-circuit fault.

Can I keep driving?

If the engine runs smoothly and the warning light is steady, limit driving and arrange diagnosis soon; poor mixture can increase fuel use and emissions and may damage the catalytic converter. Stop driving if the light flashes, the engine shakes severely, or power drops sharply.