P064E: Internal Control Module O2 Sensor Processor Performance Bank 2

What it means

An internal self-test in the control module reports a fault in its processing of the "oxygen sensor processing, bank 2" value. The module computes and cross-checks this value redundantly inside its own processor; when the results disagree, the code sets. It points to a hardware or software fault inside the module itself, not to a defect of the external sensor. Causes are an internal processor or memory fault, corrupted control-module software, or low or disturbed module supply voltage.

At a glance

• Usually lights the check-engine light
• Affects emissions; the car can fail an emissions test

How it works

The engine control module runs an internal self-check on its oxygen-sensor processing for bank 2, the side opposite bank 1 on engines with two banks. This code sets when redundant internal calculations for bank 2's oxygen-sensor processing disagree; it indicates a possible module processing, software, or supply issue rather than directly identifying a failed external oxygen sensor.

Common causes

Most likely first.

1. Internal software anomaly
2. Module software outdated, reflash may resolve
3. Supply voltage outside specification

Symptoms

• Check engine light on
• Increased fuel consumption
• Possible rough idle or hesitation
• Failed emissions test

How to diagnose it

1. Save freeze-frame data and scan all modules for control-module, voltage, and bank 2 fuel-trim or oxygen-sensor codes.
2. Check battery condition and charging-system behavior, then inspect engine-control-module power and ground connections for looseness or corrosion.
3. Review live data for bank 2 oxygen-sensor signals and fuel trims to see whether separate sensor or mixture faults are present.
4. Inspect the engine-control-module connectors and grounds for moisture, damage, or poor terminal contact that could disturb its supply.
5. Check module supply voltage and ground under load against the manufacturer's specification, and correct instability before further assessment.
6. If supply is stable and related external faults are absent, check for an applicable module software update and evaluate the engine control module's internal processor.

Common fixes

• Repair a weak battery, charging fault, or poor engine-control-module ground that is disturbing module supply.
• Repair damaged or corroded module power and connector terminals.
• Update engine-control-module software if an applicable manufacturer update addresses the self-check fault.
• Repair any separately confirmed bank 2 oxygen-sensor or mixture fault found during diagnosis.
• Repair or replace the engine control module if its bank 2 processing fault persists with stable supply and current software.

Can I keep driving?

If the engine runs smoothly, a short trip may be possible, but increased fuel use or rough running can worsen and the vehicle may fail an emissions test. Avoid long trips if it hesitates or runs roughly, and address the module and bank 2 data fault promptly.