B0110: Camera Washer Actuator G

What it means

The control module detected a fault associated with camera washer actuator G. It sets the code when the actuator circuit or operation does not meet the module's expected range.

How it works

Camera washer actuator G operates the washer mechanism assigned to camera G. The control module checks whether the actuator circuit and operation are within its expected range; this code is set when they are not, though it does not identify the exact cause.

Common causes

Most likely first.

1. Faulty washer actuator
2. Damaged wiring
3. Loose or corroded connector
4. Low washer fluid or blocked plumbing

Symptoms

• Camera cleaning warning
• Reduced camera-based assistance
• Warning message

How to diagnose it

1. Read the relevant module’s codes and freeze-frame data, then check live data or the supported output test for camera washer actuator G to confirm the fault.
2. Check washer fluid level and inspect camera G’s nozzle and plumbing for blockage, leaks, or a seized mechanism.
3. Inspect actuator G’s connector and wiring for looseness, corrosion, moisture, or damage.
4. Command actuator G with the scan tool and observe whether it operates and whether the fault returns.
5. Test actuator G’s power, ground, and control circuit for opens or shorts against the manufacturer’s specification.
6. If the actuator and wiring pass, check the washer control module’s driver output and connections.

Common fixes

• Refill washer fluid or clear a blocked camera G nozzle or hose.
• Clean or secure actuator G’s connector and repair damaged wiring.
• Replace a faulty camera washer actuator G.
• Repair the washer control module output or replace the module if tests confirm an internal fault.

Can I keep driving?

Driving is usually possible, but camera G may remain dirty and reduce the performance of camera-based assistance. Keep its view clear and do not rely on affected features when visibility is impaired.